ULBRICH Combination shock absorber and spring test machine

Trenutno se nahajate: proizvodi> Stroji, naprave, industrijska hidravlika> Stroji in naprave s hidravličnim pogonom in elektronskim krmiljenjem> ULBRICH Combination shock absorber and spring test machine

Izberi izdelek ULBRICH Naročniško namenski stroji in napraveULBRICH Air spring test machineULBRICH Assembly press with rotary table (inside)ULBRICH Assembly press with rotary table (outside)ULBRICH Autofrettage systemULBRICH Bolt Assembly PressULBRICH Buffer test machineULBRICH C Inteligentne stiskalnice za montažo in kontroloULBRICH Chockblock testing machineULBRICH Clutch Test MachineULBRICH Column pressULBRICH Combination shock absorber and spring test machineULBRICH Edge force measuring and lifting equipmentULBRICH Hydraulic pressULBRICH Lift and turning systemULBRICH Naprava za Preizkušanje VzmetiULBRICH Press stationULBRICH Production cell for tapered roller bearingsULBRICH Production pressesULBRICH Shock absorber test machineULBRICH Universal in-line coil spring test- and setting machine 500kNULBRICH Wave Straightening PressULBRICH Wheel pullerULBRICH Wheelset bearing housing pressULBRICH Wire rope test machineULBRICH Workshop presses

EN AT DE CZ HU SI SK HR 

Ulbrich

ULBRICH COMBINATION SHOCK ABSORBER AND SPRING TEST MACHINE

Pošlji povpraševanje za ta izdelek!

This combination machine was specially developed for use in workshops for trams, commuter trains and metro. It is not only possible to test shock absorbers in any mounting position, but also coil springs up to a test load of 50kN can be tested. Just a few simple steps and the shock absorber test bench becomes a spring testing machine.

In use as a shock absorber test bench:

• Max. Tensile force: 25 kN 
• Max. Stroke: 360 mm - corresponds to +/- 180 mm from the middle position 
• Max. Speed: at cyclic load 300 mm / sec. 
• Test position: infinitely adjustable from 0 ° to 90 ° 
• Max. Diameter of specimen: 440 mm 
• Installed power: 7.5 kW 

In use as a spring testing machine:

• Max. Pull-push force: 45 kN 
• Max. Stroke: 360 mm 
• Max. Speed: at full load 40 mm / sec. 
• Test layer: usually vertical 
• Max. Diameter of specimen: 440 mm 
• Installed power: 7.5 kW

Pdf:

• TDS ULBRICH Combination shock absorber and spring test machine eng.pdf